According to NFPA 72, the mounting height of a strobe light is between ___________ inches and __________ inches above finished floor.
What is the color code requirement for a spot-type heat detector rated at 200 degrees Fahrenheit? a. White b. Blue c. Red d. Green Share your answer by commenting.
Unless otherwise required by the AHJ, only the elevator lobby, elevator hoistway, and elevator machine room smoke detectors, or other automatic fire detection, shall be used to________________________. a. Send a specific and coded signal to the FACP. b. Recall elevators… Continue Reading
Monitoring for integrity shall not be required for the interconnection between listed equipment within __________________. a. the same building. b. the same zone. c. a common enclosure. d. the same floor.
The secondary power supply shall automatically provide power to the protected premises system within __________ whenever the primary power fails. a. 5 seconds b. 10 seconds c. 60 seconds d. 90 seconds Please comment to share your answer and include… Continue Reading
Fire alarm cables were installed using RMC. What must be installed/provided when the conduit is terminated at boxes, fittings and or other enclosures? a. Conduit support straps within 1 foot of where the conduit terminates. b. Expansion fittings for the… Continue Reading
Fire alarm system circuit disconnecting means shall be permanently identified with the text ___________________. a. FIRE ALARM b. DISCONNECT SWITCH c. FIRE ALARMS DISCONNECT SWITCH d. EDS Video answer in comments. Want more questions like these? Check out our NICET… Continue Reading
When 2 resistors are connected together their total resistance is calculated at 500 Ohms. What is the resistance value of each resistor? a. R1 = 100 Ohms / R2 = 300 Ohms b. R1 = 1,000 Ohms / R2 =… Continue Reading
What is the maximum amount of 12-gauge THHN conductors that can be installed in 3/4 inch Rigid Metal Conduit? a. 8 b. 10 c. 14 d. 16 Answer in comments. Want more questions like these? Check out our NICET Level… Continue Reading
Actuation of a manual pull station at the protected premises shall occur within ________ seconds after the handle is pulled. a. 10 seconds b. 60 seconds c. 90 seconds d. 200 seconds Answer in comments. Want more questions like these?… Continue Reading